Kitchen sinks accessories. Useful collection for sinks.
Kitchen Accessories,Kitchen Equipment,Kitchen Board,Kitchen Supplies Jiangmen MEIAO Kitchen And Bathroom Co., Ltd. , https://www.meiaosink.com
If you use unreasonable will shorten the life of the submersible pump, so the correct use of the method is to extend the submersible pump life, reduce economic losses, an important factor. First, for the submersible pump, before starting to do some necessary checks: the submersible pump shaft rotation is normal, with or without stuck phenomenon; impeller position is normal; cable and cable plug without rupture, abrasions and broken phenomenon Wait. Operation should pay attention to observe the voltage changes, the general control of the rated voltage within ± 5%. In addition, the location of the submersible pump in the water is very important, as far as possible should be selected in the water, non-silt, good water quality, vertical suspension in the water, not allowed to cross, so as not to fall into the mud or suspended solids plug submersible pump inlet , Resulting in a sharp drop in water or even pumping to the water. Second, for the self-priming pump, should be placed in a well ventilated place to run, in order to facilitate rapid cooling, reduce the motor temperature. Otherwise, prolonged operation, easy to burn the motor. If a farmer is using a self-priming pump, the motor is overheated and the coil burned out because the plastic film covering the motor is not removed. In addition, before starting, be sure to check the submersible pump body of water, otherwise, not only affect the self-priming performance, but also easy to burn shaft seal components. Under normal circumstances, submersible pump 3-5 minutes after the start that should be the water, or should immediately stop checking. Third, when the submersible pump fails, should not disassemble yourself. Because of their demolition, I do not know where the fault is caused by blindly dismantling a pass; Second, there is no special tools and often damage the original parts intact. The best way is to have the experience, the maintenance of scale maintenance, and timely replacement of "over age" parts and some wearing parts. Under normal circumstances, submersible pumps should be repaired once every six months, to eliminate "sick" work. Fourth, in the non-use period, the submersible pump should be promptly removed from the water, and emptying the pump water, especially in the cold winter. Then place it in a dry place, the conditional user can also apply grease to the key parts of the submersible pump, add lubricants in the bearings to prevent corrosion of parts. In addition, the submersible pump of non-use period, not the longer the better. If you do not use for a long time, not only easy to rust parts, but also reduce the life of submersible pumps.