The original tape on the sun board. It is not resistant to aging only for temporary protection of the edge of the board. In the installation process, the board is cut according to the size. After the material is cut, the special hole must be sealed with the engineering special tape according to the requirements of the installation procedure, and the original tape is replaced. The special tape for installation engineering should have good weather resistance, long-term use without losing its cohesiveness and mechanical strength, and when the tape is applied during the installation operation. Pay attention to the following points; (1) Ensure that the edges of the board are smooth. (2) To blow all the holes clean, the compressed air must be free of any impurities and dry. (3) Be sure to cover the tape with the profile and metal cover, and the U-shaped protection groove at the end. After the installation is completed, there should be no exposed parts. (4) Check the tape for damage before the final installation of the pre-installation. If the damaged tape is found, it must be replaced. Features and Advantages: Led Linear Light,Multi Utility Linear Light,Bedroom Linear Light,Kitchen Led Linear Light Guangdong harmonglobal Lighting Industry Co.,Ltd , https://www.harmonglobal.com
1.simple industrial appearance design,bloom the beauty of pure line. Easy to install.Integrated light into buillding ,add color for city.The surface of the lamp body is oxidized,wear-resisting and rust-proof,which made it able to resist the bad weather efffectively.
2.Combined with LED light Angle calculation, a variety of light ways, to show the uniform smooth bright soft and comfortable effect.The unique process design of the end cover can effectively solve the dark area between the lamp and the lamp.
3.Core configuration aspect:multi-color with DMX control system, using high grey grate 65536 chips , refresh rate reach 4K.The program plays smoonthly with the speed upto 25ms/frame.
4.Quickly connect male and female plugs, precise pin core hole position, prevent plugs connection worong direction, the connection is firm,stable and reliable, easy to install and remove, not easy to disconnect.
5.The Wires come out from middle body,can transmit to remote place.with groove for hiding wire , can pass two" BW6" wires(outside diameter 6.2MM).
6.The lamp body waterproof fill with fully glue,protection rate upto IP66.