1. Clean the floor before installation. Especially the concave place should be removed. 2. Arrange the cable, telephone line and network cable. 3. If the heating pipe groove at the wall is too large or too deep, it is best to fill it with dry sand. Do not use cement to seal it! 4. If there is a water pipe, the heating pipe must be notified to the installation master to avoid accidents! 5, sprinkle the floor medicine, the corners and the doorway should be sprinkled. 6. Ask the installation master to remove the bottom of the door cover and let the floor be inserted under the door cover, so that the installation is more robust. 7. Paving the moisture-proof floor mat. If it is a geothermal ground, it must use a special floor mat for geothermal. 8. It is best to open the package before installation. Check if there are any corners on the floor surface, but it is best to prevent it. 9. Be sure to keep the floor and wall 8mm telescopic space. 10. Make sure each room is a self-contained section. If it is a large area, disconnect once every 8-10 meters. 11. When installing the corner line, it is best to use the yin and yang angle. Because the yin and yang angle is used, the corner joint will be strong. 12. It is best to use copper strips or stainless steel strips for the floor and kitchen floor tiles. Never use ordinary plastic strips. 13. Be sure to check it again once before installing it. LED Emergency Light Remote Head Led Emergency Light Remote Head ,Emergency Light Remote Head ,Emergency Exit Light With Remote Head,Led Remote Head Emergency Light NINGBO JIMING ELECTRIC APPLIANCE CO., LTD. , https://www.feituosafety.com