How to fix a toilet leak How to fix a toilet How to do a toilet Led Square Downlight,Led Square Recessed Led Downlight,Led Recessed Downlight,Square Led Downlight Foshan Extrlux Co., Ltd. , https://www.extrlux.com
Selection method:
How to determine whether the toilet tank water leakage, in addition to the sound of obvious drip from the obvious, this can not be noticed in the normal situation, the simplest way to check is to drop in the toilet tank with colored ink, stir to see if the toilet water is The outflow of colored water, if any, indicates where the toilet leaks. As a reminder, it is best to choose a higher height tank, so that the momentum is good.
Toilet flushing methods can be divided into "flush type", "siphon flush type" and "siphon swirl type". The flush type and siphon flush type have strong sewage discharge capacity, but they have a loud sound when flushed. Whirlpool water consumption is large at one time, but it has a good mute effect.
Also pay attention to the glazed toilet, good quality toilet glazed smooth and smooth without foaming, color saturation. After inspecting the glazed surface, you should also touch the sewer of the toilet. If the rough surface is not glazed, it can be easily contaminated.
Water directly determines the service life of the toilet. Brand toilet and ordinary toilet water quality is very different, the identification method is to listen to the sound of the button, water quality issued a crisp sound quality. 
First decide where the toilet device is. First, the bottom of the toilet flushing the sewage outfall to the air discharge nozzle, according to the size of the toilet bowl outside the base, determine the fixed toilet bottom hole corner position, and drilling with a percussion drill. In general, the hole depth is about 6CM.
Device toilet base. Use a steel shrink bolt to drill into the aerial drill hole. Put the bottom corner of the toilet into the shrink bolt and tighten the nut to fix the toilet bowl.
Step 3: Install the water tank. (The one-piece type toilet does not need to install a water tank.) Based on the hole position of the rear wall of the toilet box and the height of the water tank device, it will find a corresponding position on the wall to fix and drill the eye, knock in the steel shrink bolt, and put the water tank on it. Hold it in position, then insert the wall hole into the shrink bolt, add a 3 mm thick nylon washer, and then tighten the nut.
The fourth step: device convergence. Of course, the connecting pipe between the water tank and the toilet base can be a copper pipe or a plastic pipe; the connecting pipe between the water pipe and the bottom of the tank can use a stainless steel corrugated pipe, etc.; and an angle valve should be installed at the connecting point of the water pipe. Water control valve. 