Lighting distribution box (disc) installation work instructions

1. Scope of application

It is suitable for the distribution box (disc) installation in the electrical installation of buildings.

2. The main equipment

2.1 Mechanical Equipment: Welders, etc.

2.2 General and special tools: hand hammers, hacksaws, wire strippers, crimping pliers, sleeve wrenches, movable wrenches, vise, hand drills, hammers, bench drills, mortar buckets, etc.

2.3 Detection device: tape measure, iron level ruler, steel ruler, wire drop, megohmmeter, leakage protector tester, etc.

3. Finished product protection

3.1 After the distribution box (disc) is installed, product protection measures should be taken to avoid damage.

3.2 When installing the panel (pan) panel, care should be taken to keep the wall clean.

3.3 When constructing secondary shotcrete, be careful not to contaminate the distribution box (pan).

3.4 The electrical components in the box shall be installed after the civil doors and windows are installed and locked.

4. Safety and environmental protection measures

4.1 When installing power distribution boxes, plates, and appliances, it should be protected against falling and falling.

4.2 Strictly observe the operating rules when welding.

4.3 The solid waste is stored in a centralized manner and regularly cleaned.

4.4 Before the test of power transmission is on, it is necessary to set a bold warning sign. Casual personnel must not enter the isolated area. Non-designated personnel are prohibited from operating electrical appliances.

The information in this article comes from the Internet and was reorganized and edited by China Rescue Equipment Network.