Phlizon COB series Grow Light, best full Spectrum designed to perfectly match large areas of indoor plants, hydroponics horticulture agriculture, and greenhouse, especially for indoor Plant.
3000K 5000K Cree COB and Epistar dual-chip,most efficient spectrum,high PPFD.Instead of having dozens of small diodes, COB style LED Grow Lights typically only have a handful of huge COBs, each with strong lenses to direct the light down into the plant.The big aluminum heat sink to protect the grow lights from high temperature,good cooling,long lifespan.Photosynthesis and promote healthy growth budding and flowering. PH-B-L3 Shenzhen Phlizon Technology Co.,Ltd. , https://www.szledplantgrowlights.com
2. Inspect each part for grease.
3. Turn the exciter by hand. When the spindle is requested to rotate, the spindle can rotate flexibly without friction or jamming. (Special note: there must be no debris in the exciter inside and outside protective cover.)
4. Check the fixed facilities around the moving part of the sieve machine, such as the material discharging chute, the sieve lower funnel and the accumulation material under the sieve, if the collision is possible, and the distance is not less than 80mm.
5. Check if the motor wiring is correct. Is the steering correct?
6. If there is any abnormality before the test run or if the springs are abnormally beaten, the screen machine will not be able to operate normally. Stop the vehicle immediately, find out the reason, and troubleshoot before driving.
7. The start should be smooth, rapid, and with no lateral oscillation (less than 1mm).
8. After the start-up operation is normal, it needs to run continuously for 8 hours (minimum not less than 4 hours). Observe whether the screen has been running normally. The bearing temperature is generally 50°C--65°C, exceeding 75°C is not normal.
9. If the vibrator sounds abnormally or the temperature rises sharply during driving, stop immediately and check the cause.
10. Check the vibration of the sieve machine, whether the amplitude is in compliance with the requirements, and the amplitude can be measured at six points on both sides of the sieve, front, middle and back.
11. Measure the resonant amplitude of starting and stopping. The amplitude at resonance is 5 times normal, and the maximum is 8 times. The screen should not collide with any hard material or structure when it is in operation, on or off.
12. After 8 hours of operation, check whether all tightening bolts of the sieve are loosened. If there is any looseness, tighten the bolts again and tighten the bolts of the sieve plate clamps all at once. Fasten the bolts every 24 hours.
13. The current should be stable during operation.
phone
These are rapidly gaining in popularity and are known for having deep penetration into the plant canopy. 1000w/1500w/2000w /2500w /3000w COB light, they will give you more options when your plants need different strength of illumination.
1. Before driving, you must check whether each part is installed correctly and whether all fastening bolts are tightened.