When I want to exit programming, such a message appears: "EEPROM UNIT IS INSTALLED"? Why can't the host answer when the phone is remotely controlled? Why does the RP128 host only dial the first follow-up phone? Why is the main power lamp blinking or the TROUBLE lamp is on? Estradiol Benzoate,Dexketoprofen Trometamol,Piroctone Olamine Meikewote Trade Co., Ltd. , http://www.rubber-auxiliarys.com
A: Please try to power on the motherboard again, and check whether the COM port on the computer is confirmed and working normally.
A: Because the number of rings is 12 times. Enter the programming menu and change the number of U/D ringtones to 2-3 times.
Answer: The RP128 host can be used independently in 8 partitions. The system default zone belongs to the first partition. The number of follow-up telephones that can be set is 8, and the factory value is set as follows: the first following phone number corresponds to the first partition, the second follows the phone number corresponding to the second partition, and so on.
Follow the phone number can be set to 1-8 partition alarm in any zone are dialing, programming reference RP128 host installation programming manual 5-77 content.
Answer: This is caused by a host failure. The failure includes: the system time is not set, the battery voltage is low, the telephone line is not connected, and so on. Faults can be viewed in the host menu.