It may be due to rust and iron rust in the heating system or air in the heating system causing air blockage, resulting in obstruction of the system's water circulation. Then there is the unreasonable design of the radiator to cause the system water circulation to approach the road, and it can also cause half of the heat to be cool. This situation can close the valve of the return pipe. Heating deflation and common troubleshooting methods 1. The overall heating is not hot When this fault occurs, the valve is usually closed before heating, and the supply and return valves can be opened. 2. The heating is half hot and half is not hot. There is water inside the heating. The reason for this failure is that the gas in the radiator has not been drained, and the gas valve needs to be opened to release air until water flows out. At the other end of the heating control valve, there is a deflation valve that can be adjusted with a screwdriver, and it is turned counterclockwise to release the warm air and the heating can become warm. Need to be deflated multiple times, once or twice is not enough to put it clean, and it will be released once every other time. Until exhausted. The bathroom's heating bleed valve is at the top of the heating. Remind you: After the operation, if the fault cannot be eliminated, notify the maintenance personnel. 3. In a house, some of the heating and heating are not hot In this case, the main flow of each heating is not uniform, that is, uneven resistance distribution, need to adjust the inlet valve of each radiator. After debugging, you can solve this problem. 4. The heating in the home is very hot, but the temperature in the room is very low In this case, the selected heat sink is too small and the number of heat sinks needs to be increased. Therefore, when you buy a radiator, you must actually measure it, and calculate the size of the radiator based on the factors such as orientation, surrounding environment, and pressure. 5. Common faults: Heating pipe temperature is not enough, room temperature is too low. Remedy: Inlet water temperature is low, increase the inlet temperature. By the property inspection system. 6. Common faults: Water leaks into the inlet and outlet valves (close to the heater). Remedy: Close the inlet and outlet valves. Notify the installation team of maintenance. 7. Common faults: water leakage outside the inlet and outlet valve (near the main road). Remedy: Inform the property of the semi-closed system valve; notify the installation team for maintenance. Hydroelectric renovation villa design heating room bathroom design overall bathroom bathroom door bathroom leak
Laboratory Peristaltic Pumps operates by pumping fluids through the Peristaltic Pump tube squeezed rotating rollers in the pump head that squeeze the liquid out of the tube with compression force.
The peristaltic pump is a liquid delivery device that can control the flow rate. It has the characteristics of high delivery accuracy, strong corrosion-resistance, small shearing effect, simple operation, easy maintenance, and can effectively avoid cross-contamination. It has a very wide range of laboratories. Applications. From cell culture to in vitro organ research, from material preparation to water treatment technology optimization, from food ingredient extraction to food preparation technology improvement, Peristaltic Dosing Pumps may be used as power to achieve accurate fluid transmission and processing operations during the experiment.
Laboratory Peristaltic Pumps,Lithium Mining Peristaltic Pump,Liquid Additive Peristaltic Pump,Drugs Dispensing Peristaltic Pump Baoding Chuangrui Precision Pump Co., Ltd. , https://www.crprecisionpumps.com